Okay, started buying parts for the skull.
Bought the Dubro 4-40 Steel Threaded Rod Ends, but accientally bought the Dubro 4-40 Solder Kwik-Links instead of the 2-56 - I'll order those soon. Looking for the right diameter ball bearing ball size - the ones in the Sideshow T-700 bust aren't even balls, but just small ovals and the pincher parts look weird.
Anyone know what size Torq-Set screws were used on the side of the jaws for the T1 skull and which type screw and size was used for T2?
And I need help with figuring out the correct sized Mac Master-Carr jaw piston parts - Hinged Threaded Round Standoff male/female parts - as I don't really understand imperial measurements and haven't found a retailer here in DK or Europe. Another thread on the forum seems to indicate this size - 3/16" OD, 1/4" x 3... something is cut off, so it's hard to make out exactly what it says in the picture. There are two versions of the parts - a short female part version that goes into the bottom jaw and a long female part version that goes into the main skull. And for some reason the bottom hinged part seems uneven in size - did they machine the part not connecting to the skull smaller or are they available like that as well?
Also wondering whether the main body of the jaw pistons is a RC car or airplane part. Anyone know what it is?
, on Flickr