Can't wait to see this printed and painted up and shown off. Such a lovely idealized piece of averaged symmetrical perfection.

ok, it's been a while but, the forms for the helmet are finally done, next up is having them printed. once they are printed. they will be prepared and then final modifications will be made to get them ready for molding. stay tuned.

ok guys had to reprint. the first one failed. but this one is looking better. and almost done, back and dome are still needed to be done. coming along slow but sure,

Cool. Looks kinda like a CR-10. What layer height are you printing in and what will you use to smooth the layer lines?

yes it is CR-10 i believe, and the layer height is .1 , will be sanding and possibly using bondo or aves. whatever David Carty thinks is bets for he will be the one doing it. ;)

Oh, you should have gone with 0.05 layer height. It takes longer, sure, but it's better for a lot of fine detail. However, once you've started with one layer height it's not good to switch to another for other parts, as it will show.

well im not the one who is printing it, and the person who is doing it recompensed to do it at .1 doesn't take as long and less change of failure. it doesn't really look all that bad, some bondo and sand paper will take care of all that.

face is done, this is a raw print, so there is prep work needed, back and dome are next, but very pleased with how this turned out cant really complain. no warping and all shapes and forms were retained.
more to come.

That thing is looking awesome

thank you

dome done, last piece is the back and then its prep and assembly for the molds.

Looks phenomenal. Really want to see this finished up and put together.

thanks buddy, so do i cant wait, soon, soon

ok Back is finished. :"This is where the fun begins," stay tuned.

construction and prepping has begun. here is the cap and rear component assembled and being prepped for the molding process. still a LONG way to go.