Hi
here is my other little project on the go, a ROTJ DV REVEAL Helmet.
I have been collecting parts for this project for about 5 years or so and am just missing a few pieces now.
Some of you may know me from the RPF selling bits and pieces for the reveal.
The basis is a Portumac helmet that I swapped for a Glenross screw 5 years ago. It is my first DV helmet apart from the sad looking one I have for sale which was a little too ambitious for me. I am looking for an accurate ROTJ helmet, Any suggestions? I have an Elstree coming and thought I might take a cast from it to use as a basis? Is that accepted if it's for my own use?
I have a set of metal parts that I got from the VaderDoctor, Original copper vents from a Photomultiplier, a few original Glenross screws and a mass of other bits I have begged borrowed bought and stolen!
anyway here are some photos of what I have found so far.
THE START......
Then I cut the Jaw off.....
:
I then sanded off the keys and stuff on the crown as I have some newer metal ones
Then I cut out the vent squares...
then see what the vents look like.
Some parts I have amassed over the years....
My own sculpted part in clay. I will cast the black part out of a rubbery poly and Russrep is doing the brass part
Brace screws I had commissioned by Russrep
Brace mesh
Glenross Expansion screws
Copper Vents
Mouth/jaw parts
Crown keys and bits
Forehead Parts
That will do for now. I'll upload some more parts when I have the time........
What do you think so far?
:star: :arrow: :affraid: