it complements the MR/e-FX Ep3 Clone and Stormy lids.
That might be the only reason for me to buy it anyway...
A few weeks ago CGClone posted this list. (I hope you don't mind CGC)
The parts that bother me right now as it stands, taken from the digital files or not - that simply dont match up well to screen are:
1) The hole in the "ear" column. Its to low and too small, misplaced.
2) The dome is too round on top. It has a more elongated elegance, its not as purely round as it seems.
3) The line/outer ridge the happens right under ear column is too bulbous
4) The ridge underneath that is too soft. Should be a sharper angle.
5) The ear column protruding into the flat cheek is too deep, not much, but more than it should be.
6) The corners of the T-visors are not round, only rounded on the bottom, the top of that corner should be much more angular.
7) The visor is set wayyy to back, its actually almost more on top.
8) The t-visor part where it curves down to the nose needs to be a touch sharper
9) The back channel that is under the round protrusion (you dont see it on the efx promo pic, its on the back of the helmet) is too wide.
10) The square dots on the back of that protrusion are off center, outwardly, they should be centered.
11) That cheek curve indention just under the t-visor caves in some, should be flat.
12) The continuation behind the ear column near the near of the helmet, it bends inward, it should be straight up and down.
Now I know theres some of this due to laying in the resin and thick fiberglass, etc from production, but most of it is not.
I am just stating what I see. Some may not agree, just sharing.